Manual

Alarm Management

DVR User Manual

9.5.4 Buzzer

Click Start Settings Alarm Event Notification Buzzer to go to the buzzer configuration

interface. Set the delay time of the buzzer and then click “Apply” to save the setting. You can

click “Test” to test the buzzer.

9.5.5 Push Message

Click Start Settings Alarm Event Notification Push Message to go to the interface as

shown below. Check “Enable” and then click the “Apply” button to save the settings. If Push

Server is online, it will push messages to the mobile clients.

9.5.6 Alarm Server

Go to Alarm Alarm Server interface as shown below.

Enable the alarm server and enter server address and port of the alarm server. Then select

protocol. If “Send Heartbeat” is enabled, set the interval times. After that, test the effectiveness

of the alarm server. Having tested successfully, please click “Apply”. When an alarm occurs,

the device will transfer the alarm event to the alarm server. If an alarm server is not needed,

there is no need to configure this section.