Manual

Alarm Management
DVR User Manual
76
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”,
“Pop-up Video” and “E-mail”. The alarm handling setting of line crossing alarm is similar to
that of the sensor alarm (see 9.1 Sensor Alarm for details).
Click “Apply” to save the settings. You can click “Crossing Config” to go to the line
crossing configuration interface.
9.3.4 Intrusion Detection
Intrusion Configuration:
Alarms will be triggered if someone
or something intrudes into the pre-defined area.
Click Start Settings Camera Intelligent Detection Intrusion Detection to go to the
following interface.
Select the camera, enable the intrusion detection and set the duration.
Select the alarm area. Up to 4 alarm areas can be set up.
Draw the alarm area of the intrusion detection. Refer to the interface as shown below.
Check “Draw Area” and then click around the area where you want to set as the alarm area in
the imag
e (the alarm area should be a closed area). Uncheck the “Draw Area” when you finish
the drawing. Click the “Clear” button to delete the alarm area.
Click “Apply” to save the settings.
Click “Processing Mode” to go to the alarm handling configuration interface of intrusion
detection.
Alarm Management
DVR User Manual
76
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”,
“Pop-up Video” and “E-mail”. The alarm handling setting of line crossing alarm is similar to
that of the sensor alarm (see 9.1 Sensor Alarm for details).
Click “Apply” to save the settings. You can click “Crossing Config” to go to the line
crossing configuration interface.
9.3.4 Intrusion Detection
Intrusion Configuration:
Alarms will be triggered if someone or something intrudes into the pre-defined area.
Click Start Settings Camera Intelligent Detection Intrusion Detection to go to the
following interface.
Select the camera, enable the intrusion detection and set the duration.
Select the alarm area. Up to 4 alarm areas can be set up.
Draw the alarm area of the intrusion detection. Refer to the interface as shown below.
Check “Draw Area” and then click around the area where you want to set as the alarm area in
the image (the alarm area should be a closed area). Uncheck the “Draw Area” when you finish
the drawing. Click the “Clear” button to delete the alarm area.
Click “Apply” to save the settings.
Click “Processing Mode” to go to the alarm handling configuration interface of intrusion
detection.