Manual

Alarm Management
DVR User Manual
72
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”,
“Pop-up Video” and “E-mail”. The alarm handling setting of motion alarm is similar to that of
the sensor alarm (see 9.1 Sensor Alarm for details).
Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion
configuration interface.
9.3 Intelligence Alarm (IP Camera Dependent)
9.3.1 Object Detection
Object Detection Configuration:
Click Start Settings Camera Intelligent Analytics Object
Detection to go to the
following interface.
Select the camera, enable the object detection and set the duration and detect type. There
are two detect types: Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined
detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drew
by the users.
Select the alarm area. A maximum of 4 alarm areas can be set.
Draw the a
larm area of the object detection. Refer to the interface as shown below. Check
“Draw Area” and then click around the area where you want to set as the alarm area in the
image (the alarm area should be a closed area). Uncheck the “Draw Area” when you finish the
drawing. Click the “Clear” button to delete the alarm area.
Click “Apply” to save the settings.
Click “Processing Mode” to go to the alarm handling configuration interface of object
detection.
Alarm Management
DVR User Manual
72
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”,
“Pop-up Video” and “E-mail”. The alarm handling setting of motion alarm is similar to that of
the sensor alarm (see 9.1 Sensor Alarm for details).
Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion
configuration interface.
9.3 Intelligence Alarm (IP Camera Dependent)
9.3.1 Object Detection
Object Detection Configuration:
Click Start Settings Camera Intelligent Analytics Object Detection to go to the
following interface.
Select the camera, enable the object detection and set the duration and detect type. There
are two detect types: Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined
detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drew
by the users.
Select the alarm area. A maximum of 4 alarm areas can be set.
Draw the alarm area of the object detection. Refer to the interface as shown below. Check
“Draw Area” and then click around the area where you want to set as the alarm area in the
image (the alarm area should be a closed area). Uncheck the “Draw Area” when you finish the
drawing. Click the “Clear” button to delete the alarm area.
Click “Apply” to save the settings.
Click “Processing Mode” to go to the alarm handling configuration interface of object
detection.