Manual

Alarm Management
DVR User Manual
69
9 Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each
camera and then set up the alarm handling of each camera.
Click Start Settings Alarm Sensor Alarm to go to the following interface.
Select the alarm type (NO or NC) according to trigger type of the sensor.
Enable the sensor alarm of each camera.
Check the “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and enable or disable
the “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail” as required.
Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration: it refers to the interval time between the adjacent motion detections. For instance, if
the duration time is set to 10 seconds, once the system detects motion, it will go into alarm and
would not detect any other motion (specific to camera) for 10 seconds. If there is another
motion detected during this period, it will be considered as a continuous movement
; otherwise
it will be considered as a single motion.
Record: check it and then the “Trigger Record” window will pop up automatically (you can
also click the “Configure” button to pop up the window). Select camera on the left side and
then click to set the camera as the trigger camera. Select trigger camera on the right side
and then click to cancel the trigger camera. Click the “OK” button to save the settings.
The trigger cameras will record automatically when the sensor alarm
is triggered.
Snapshot: check it and then the “Trigger Snapshot” window will pop up automatically.
Configure the trigger camera in the window. The trigger cameras will snap automatically when
the sensor alarm is triggered.
Push: check it and choose ON or OFF. If it is ON, the system will send messages when the
sensor alarm is triggered.
Alarm-out: check it and then the “Trigger Alarm-out” window will pop up automatically.
Alarm Management
DVR User Manual
69
9 Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each
camera and then set up the alarm handling of each camera.
Click Start Settings Alarm Sensor Alarm to go to the following interface.
Select the alarm type (NO or NC) according to trigger type of the sensor.
Enable the sensor alarm of each camera.
Check the “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and enable or disable
the “Buzzer”, “Pop-up Video”, “Pop-up
Message Box” and “E-mail” as required.
Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration: it refers to the interval time between the adjacent motion detections. For instance, if
the duration time is set to 10 seconds, once the system detects motion, it will go into alarm and
would not detect any other motion (specific to camera) for 10 seconds. If there is another
motion detected during this period, it
will be considered as a continuous movement; otherwise
it will be considered as a single motion.
Record: check it and then the “Trigger Record” window will pop up automatically (you can
also click the “Configure” button to pop up the window). Select camera on the left side and
then click to set the camera as the trigger camera. Select trigger camera on the right side
and then click to cancel the trigger camera. Click the “OK” button to save the settings.
The trigger cameras will record a
utomatically when the sensor alarm is triggered.
Snapshot: check it and then the “Trigger Snapshot” window will pop up automatically.
Configure the trigger camera in the window. The trigger cameras will snap automatically when
the sensor alarm is triggered.
Push: check it and choose ON or OFF. If it is ON, the system will send messages when the
sensor alarm is triggered.
Alarm-out: check it and then the “Trigger Alarm-out” window will pop up automatically.