Manual

PTZ
DVR User Manual
45
Edit Cruise
Select the camera and cruise in the “Cruise” interface. Enter the new cruise name and then
click to save the cruise name. Click “Add Preset” to add preset to the cruise. Click
to edit the preset. Click to delete the preset from the cruise. Click one preset in the preset
list and then click to move down the preset and click to move up the preset. Click
to start the cruise and click to stop it.
Delete Cruise
Click in the camera list on the right side of the interface to display the cruise information
of the dome and then click on the top right corner of the cruise to delete the cruise.
6.4 PTZ Protocol Setting
Click Start Settings Camera PTZ Protocol to go to the interface as shown below. You
can enable or disable the PTZ and set the protocol, baud rate and address of the analog dome in
the interface. Please make sure the analog speed dome camera is connected to the DVR before
you control it.
Select the camera and enable PTZ and then set the protocol, baud rate and address of the dome
according to the settings of the dome.
Protocol: The default communication protocol of the DVR is COC. Range from: PELCOP,
PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA, COC, etc.
Address: The address of the PTZ device.
PTZ
DVR User Manual
45
Edit Cruise
Select the camera and cruise in the “Cruise” interface. Enter the new cruise name and then
click to save the cruise name. Click “Add Preset” to add preset to the cruise. Click
to edit the preset. Click to delete the preset from the cruise. Click one preset in the preset
list and then click to move down the preset and click to move up the preset. Click
to start the cruise and click to stop it.
Delete Cruise
Click in the camera list on the
right side of the interface to display the cruise information
of the dome and then click on the top right corner of the cruise to delete the cruise.
6.4 PTZ Protocol Setting
Click Start Settings Camera PTZ Protocol to go to the interface as shown below. You
can enable or disable the PTZ and set the protocol, baud rate and address of the analog dome in
the interface. Please make sure the analog speed dome camera is connected to the DVR before
you control it.
Select the camera and enable
PTZ and then set the protocol, baud rate and address of the dome
according to the settings of the dome.
Protocol: The default communication protocol of the DVR is COC. Range from: PELCOP,
PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA, COC, etc.
Address: The address of the PTZ device.