Manual

Live Preview Introduction
DVR User Manual
30
Add Scheme
Click in area 1 to create a new scheme. Click on the top right corner of the scheme
to delete it.
Configure Scheme
a) Select a scheme in area 1 and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b) Select a camera window in area 2 and then double click the camera in area 3. The camera
will be added into the selected window. One camera in the same scheme cannot repeat. You
can right-click menu “Clear” in area 4 to remove a single camera or click to remove all
the cameras.
c) Click “Apply” to save the settings.
Start Sequence View
Go to live preview interface and then click to pop up a window. Set the dwell time in the
window and then click to start scheme view in sequence. Double click the sequence view
interface to pause the view; double click again to restore the view. Click to stop the
view.
5.2.4 Spot View
Click Start Settings System Basic Output Settings Output 2 to go to the interface as
shown below.
Click on the left to create a new scheme. Each scheme can only add one analog camera.
Select a scheme on the left and then double click or drag a camera on the right to the scheme
window in the middle of the interface. After finishing the settings of all the schemes, select the
Live Preview Introduction
DVR User Manual
30
Add Scheme
Click in area 1 to create a new scheme. Click on the top right corner of the scheme
to delete it.
Configure Scheme
a) Select a scheme in area 1 and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b) Select a camera window in area 2 and then double click the camera in area 3. The camera
will be added into the selected window. One camera in the same scheme cannot repeat. You
can right-click menu “Clear” in area 4 to remove a single camera or click to remove all
the cameras.
c) Click “Apply” to save the settings.
Start Sequence View
Go to live preview interface and then click to pop up a window. Set the dwell time in the
window and then click to start scheme view in sequence. Double click the sequence view
interface to pause the view; double click again to restore the view. Click to stop the
view.
5.2.4 Spot View
Click Start Settings System Basic Output Settings Output 2 to go to the interface as
shown below.
Click on the left to create a new scheme. Each scheme can only add one analog camera.
Select a scheme on the left and then double click or drag a camera on the right to the scheme
window in the middle of the interface. After finishing the settings of all the schemes, select the