Manual

Device Management
DVR User Manual
99
11.1.9 FTP Configuration
Some models may not support this function.
Click Start
Settings Network FTP to go to the interface for FTP configuration. Check
“Enable” and enter the server name, port, username and password, max file size and remote
directory.
11.1.10 Platform Access
Some models may not support this function.
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows.
Click Start
Settings Network Platform Access to go to the interface.
Platform Access
Set “Access Type” as “Platform Software” and select “Enable” as shown below.
Check the IP address and port of the transfer media server in the ECMS/NVMS. The
default server port for auto report is 2009. If it is modified, please go to the transfer media
interface to check.
Enable the auto report in the ECMS when adding a new device. Then self-define device
ID and fill out the remaining information of the device in the ECMS/NVMS.
Enter the above-mentioned server address, port and report ID in the server interface. Then
click the “Apply” button to save the settings. Now the ECMS/NVMS system will
automatically connect this device.
11.1.11 SNMP
Click Start Settings Network SNMP to go to the interface for SNMP configuration.
Device Management
DVR User Manual
99
11.1.9 FTP Configuration
Some models may not support this function.
Click Start Settings Network FTP to go to the interface for FTP configuration. Check
“Enable” and enter the server name, port, username and password, max file size and remote
directory.
11.1.10 Platform Access
Some models may not support this function.
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows.
Click Start Settings Network Platform Access to go to the interface
.
Platform Access
Set “Access Type” as “Platform Software” and select “Enable” as shown below.
Check the IP address and port of the transfer media server in the ECMS/NVMS. The
default server port for auto report is 2009. If it is modified, please go to the transfer media
interface to check.
Enable the auto report in the ECMS when adding a new device. Then self-define device
ID and fill out the remaining information of the device in the ECMS/NVMS.
Enter the
above-mentioned server address, port and report ID in the server interface. Then
click the “Apply” button to save the settings. Now the ECMS/NVMS system will
automatically connect this device.
11.1.11 SNMP
Click Start Settings Network SNMP to go to the interface for SNMP configuration.