Manualshelf

Manual

ManualsBrandsVitek ManualsDigital Video Recorders16 Channel 5-In-1 HD-TVI / AHD / CVI / 960H / IP Digital Video Recorder, 6TB
101102103104105106107108109110
Device Management
DVR User Manual
98
11.1.7 NAT Configuration
Click Start Settings Network NAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address. Click “Apply” to save the settings.
You can scan the QRCode through the mobile client which is installed on a mobile phone or
tablet to log into the mobile client.
11.1.8 802.1X
If it is enabled, the NVR data can be protected. When the NVR is connected to the network
protected by the IEEE 802.1X, user authentica
tion is needed.
To use this function, the NVR shall be connected to a switch supporting 802.1x protocol. The
switch can be considered as an authentication system to identify the device in a local network.
If the NVR connected to the network interface of the switch has passed the authentication of
the switch, it can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
User name and password: The user name and password must be the same with the user name
and password a
pplied for and registered in the authentication server.
Device Management
DVR User Manual
98
11.1.7 NAT Configuration
Click Start Settings Network NAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address. Click “Apply” to save the settings.
You can scan the QRCode through the mobile client which is installed on a mobile phone or
tablet to log into the mobile client.
11.1.8 802.1X
If it is enabled, the NVR data can be protected. When the NVR is connected to the network
protected by the IEEE 802.1X, user authentication is needed.
To use this function, the NVR shall be connected t
o a switch supporting 802.1x protocol. The
switch can be considered as an authentication system to identify the device in a local network.
If the NVR connected to the network interface of the switch has passed the authentication of
the switch, it can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
User name and password: The user name and password must be the same with the user name
and password applied for and registered in the authentication server.