Manual

Transcendent Series: VMS for Mac OS X
29
 Alarm Trigger Setup
In the interface of Alarm Management, choose a sensor
and click “Set Alarm Trigger” button to enter the interface.
If checking “Trigger Alarm Playback”, there will be a
sound like “beep” on an alarm.
 Add Associated Preview Camera
Click to pop up a window; check cameras
and click【OK】 button to save the setting. When sensor alarm is triggered,
the alarm preview and e-map preview will popup automatically.
Select the added camera, click “Remove Associated Preview Camera” to
remove the camera.
7.2 Motion Detection Alarm
In the control panel, click “Change Camera Settings” under Device.
 Select a camera and click “Area and Sensitivity” to enter the interface as right. You can adjust the detection
sensitivity and setup the motion area.
 Click “Set the Motion Alarm” to enter the interface. Enable motion detection alarm and set the alarm trigger.
Please refer to section 3.3.2 for details.
7.3 Video Loss Alarm
In the control panel, click “Area & Camera Management” under Device.
Click “Video Loss” to enter the interface. The steps of configuring video loss are same with the device settings
please refer to the video loss chapter of device user manual.
Choose a camera and click “Video Loss of System” to enter the interface. Please refer to section 3.3.2 for details.
7.4 Alarm Preview
The interface of alarm preview will automatically pop up if the relevant alarm page and alarm preview have been
already configured.