Manual

Transcendent Series: VMS for Mac OS X
14
Click “System Trigger” under Motion Detection Alarm Setting to enter the interface.
Under the system linkage, check “Trigger to Play Audio
File”. If the motion alarm of a certain channel is triggered,
there will be a sound like “beep”.
Click 【Trigger the Big Screen】 button to select channel.
If the motion alarm of the selected channel is triggered,
the selected camera will pop up full screen.
 Video Loss Alarm Settings
Click “Video Loss” to enter the interface. The steps of
configuring video loss are same with the device settings;
please refer to the video loss chapter of device user
manual.
 Video Loss of System
Click “Video Loss of System” to set. You can check
“Trigger to Play Audio File”. If the video loss alarm of
a certain channel is triggered, there will be a sound like
“beep”.
Click 【Trigger the Big Screen】 button to select channel.
If the video loss alarm of the selected channel is triggered,
the selected camera will pop up full screen.
 PTZ Settings
Click “PTZ Protocol Configuration” under PTZ Settings to enter the
interface. You can enable or disable PTZ. From the Protocol and Baud Rate
drop-down menu, choose a protocol and a baud rate to associate with the PTZ,
and then input the address of the PTZ connecting the software.
Click “Preset Point Configuration” under PTZ Settings to
enter the interface. Enable corresponding preset points and
create a new name in the “New Name” field by selecting
the preset point. Adjust the dome direction, speed, etc by
clicking the buttons. Click【Save Position】to save the
current position of the dome.