Instructions

32
IFU-26 Rev. H | October 2021
%SPO2
Streaming Mode
98
Disconnect
Oxygen Saturation
Nonin 3150 00:0B:57:AC:66:DA
Nonin Model 3150 (Wrist)
ID of the Nonin 3150 when it appears. It should
match the ID in
Step1above.
g. VistaPoint displays “Please wait connecting...”
If you see a message asking you to conrm the
device pairing, tap Conrm.
Pairing is now complete.
4. Start Continuous Measurement
(After Pairing)
See gure to the right.
a. Apply the Model 3150 wrist unit to the wrist. Attach
the ngertip sensor to the nger.
b. Tap TakeSpO2 in the Oxygen Saturation tile
(or TakeaMeasurement on VistaPhone and then
TakeSpO2).
c. Tap UseBluetooth.
d. Tap PairNew.
e. Tap Model3150 as the model.
f. “Scanning for Devices” will display. Tap the Bluetooth
ID of the Nonin 3150 when it appears. It should
match the ID in
Step2onpreviouspage.
g. VistaPoint displays “Please wait connecting…” and
then displays the current oxygen saturation value on
the dashboard. Updated readings will continue to be
transmitted to the dashboard as long as the Nonin
3150 is operational and the sensor is applied to the
nger.
h. If the monitoring session is complete, tap Disconnect
in the Oxygen Saturation tile. This will remove the
pairing between VistaPoint and the Nonin 3150.
Error Messages During Measurement
The following error messages may be displayed in
VistaPoint when taking a measurement. See gure to the
right.
• If the dashboard displays “Finger Removed”, check
nger is inserted correctly, or tap Disconnect to stop
monitoring.
• If the dashboard displays “Low Quality Reading”,
check nger is inserted correctly.
• If pairing, place in pairing mode
• If measuring, apply to wrist and ngertip
Take Oxygen Saturation
Pair New
Use Bluetooth
Manual Entry
Currently using Bluetooth Upload.
No device is currently paired. Select
Pair New to begin the pairing process.
Tap
PairNew
TapNonin3150
(Wrist)
TapBluetoothID
Scanning for Devices
Devices Found:
00:0B:57:AC:0B:13
Tap
UseBluetooth
Reading displays
on dashboard
Tap Disconnect when
reading is no longer
required
Take SPO2
Tap TakeSPO2or
TakeaMeasurement
Pair Device or Take a Reading
If “Low Quality Reading” is
displayed, check nger is
inserted correctly.
If “Finger is Removed” is
displayed, check nger is
inserted correctly or tap
Disconnect to stop measuring
oxygen saturation.
%SPO2
Low Quality Reading
97
Finger is Removed
--
Error Messages