TDS

2172 Arendell Way. - Tallahassee, Fl. 32308 844-284-2858 (Toll Free) www.vitalcoat.com
SHINGLE SHIELD™ ROOF SEALER
2. Keep your roof clean of debris –Debris on the roof will hold water and cause the
shingle and sealer to deteriorate. Keep the valleys free of debris and keep your gutter
and downspouts clear to ensure proper drainage.
3. Keep surrounding tree branches pruned to prevent hanging over the roof. – Tree
limbs or branches touching the roof will scrub and cause damage to the sealer and
the roof. This also helps prevent varmints such as squirrels from climbing on the roof.
4. Secure loose shingle tabs. –Whenever you have a loose shingle, it can be fixed by
either replacing the shingle or using a little roof cement to secure it back into place.
Regularly inspect any caulking and flashing to prevent leaking.
5. Maintain your roof. – Keeping you roof clean is important. It is recommended to use
a professional licensed soft wash company to clean your roof. Do not allow
unqualified personnel to maintain your roof. Clean your roof annually or more
frequent if needed depending on your conditions. Do not use high water pressure
devises or harsh chemicals to clean your roof. Water and laundry grade detergents
are all that is necessary to maintain your roof.
Precautions/Limitations
• Before handling, consult the Safety Data Sheet and Container Labels for physical and
health hazard information.
• Maximum relative humidity during application and curing: 85%
• Substrate temperature must be 5.5 degrees F above dew point measured
• Humidity content of substrate must be <4% when coating is applied
• Do not apply on porous surfaces where a transfer of humidity may occur during
application
• Protect from humidity, condensation and contact with water during the 24-hour initial
curing period.
Health and Safety
Always wear proper safety equipment to protect eyes and skin. Keep a neat, clean mixing
area to avoid potential safety issues. Make sure to read and understand all SDS sheets and
become familiar with all application procedures and best practices. Recommended for use
by handyman or professionals. In case of skin contact, wash with water and soap. In case of
eye contact, immediately rinse with water for at least 15 minutes. Consult with a doctor. For
respiratory problems, transport victim to fresh air. Remove contaminated clothes and clean
before reuse. For more information, consult the material safety data sheet.
Performance and Attributes
For coatings the cured film resists the following:
Alkaline Cleaners commonly used for cleaning.
Heat Seal Test: 230 Celsius (446 F) @ 45 psi for one second face to face ----------------------- Pass
The crosslinked and cured film exhibits high heat resistance while remaining flexible and will