TDS

Rev. 19-Sep
Vital Coat
2172 Arendell Way - Tallahassee, Fl. 32308
Phone: Toll Free 844-284-2858
email: [e-mail]
Visit us at www.vitalcoat.com
Clean-up
Immediately after use, Clean tools and equipment with soap and water before the material hardens. Dispose of containers in
accordance with local and federal regulations.
Precautions/Limitations
Mixing: Separate the Vital Coat Activator (Part B) from Paver Protector Pro (Part A) and make sure you have all components
required. Mix the entire contents of (Part A) into an appropriate size container for mixing. Add entire contents of (Part B) into the
mixing container and mix using a spiral mixer of proper size for 5 to 7 minutes or longer if larger quantities until uniform. Let the mixed
sealer rest until all foam and bubbles have dissipated (Approximately 5 min.). After resting, use product immediately. If mixing multiple
containers, do not mix more than can be placed in 24 hours. Do not add water or mix with any other components not specified.
Placement: Prior to placement, always test the product on the surface to be treated in an inconspicuous area to ensure proper
adherence and satisfactory appearance. Using an appropriate high pressure pump sprayer with a minimum flow rate of .25gal/min,
apply a thin uniform layer of sealer in manageable coverage areas before moving to the next. Walk in dry areas only. Coating goes on
with a clear to slight white color but will dry clear. Avoid excessive build up. To remove excessive build up, immediately back roll with
light pressure using a medium nap roller after spraying. A second coat is recommended using the same application method. Wait a
minimum of 1 hour between coats.
Curing: Do not touch treated surface during curing. Do not add water or allow water to come in contact while curing. Protect surface
from debris coming in contact with surface while drying. Allow to dry completely for approximately 48 to 72 hours before allowing
heavy traffic on the treated surface.
Directions for Use
Surface Preparation:
Concrete and masonry surfaces must be dry, structurally sound, free of loose or deteriorated concrete and free
of dust, dirt, paint, efflorescence, oil and all other contaminants. For wood, remove and water damaged materials and clean surfaces
free of any mildew, mold, soaps, detergents and any other contaminants. Do not apply if rain is in the forecast within 24 hours.
Vital Coat is a NxTech Holdings LLC Brand. The information contained in this Technical Data Sheet (TDS) is furnished without warranty, expressed or implied. The information contained in
this document is believed to be accurate and it is the best information available. NxTech Holdings LLC assumes no legal responsibility for the use or reliance upon this data and
SPECIFICALLY DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL DAMAGES. NxTech Holdings, LLC makes no guarantees to the accuracy of suitability this information to specific
applications. By receiving and using the products referenced herein, consumer assumes all risk and liability for all use and handling.
For optimum results, condition material to 65°F to 85°F (18°C to 29°C) at least 24 hours prior to use.
Caution! This product when cured may be slippery when wet.
Never mix with any form of liquid or solvent. Improper thinning may cause sealer to delaminate in a short time frame.
Before handling, consult the Safety Data Sheet and Container Labels for physical and health hazard information.
Do not allow products to freeze in storage or during application.
It is not recommended to apply Vital Coat Sealers over other types of sealers.
Minimum surface and ambient temperature of 45°F (7°C) and rising at the time of application.
Test in an inconspicuous area prior to use.
Dried or cured sealer may be removed using diamond grinding method or solvent.