Use and Care Manual

Vital Coat Enhance & Seal Penetrating Sealer
Revision Date
_____________________________________________________________________________________________
_____________________________________________________________________________________________
1
Page 6 / 10
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Physical state
Liquid
Appearance
Milky White Liquid Dispersion
Odor
Slight
Color
Dries clear
Odor Threshold
Not applicable
Property
Values
Remarks Method
pH
9.2
Melting / freezing point
No data available
None known
Boiling point / boiling range
No data available
None known
Flash Point
93°C / >199°F
(ASTM D3278, DIN 55680, ISO 3679)
Evaporation Rate
No data available
None known
Flammability (solid, gas)
No data available
None known
Flammability Limit in Air
No data
available
None known
None known
Upper flammability limit
No data available
None known
Lower flammability limit
No data available
Vapor pressure
No data available
None known
Vapor density
No data available
None known
Density
1.01 g/cm³ at 25 °C (77 °F)
Water Solubility
Completely miscible
Kinematic viscosity
No data available
None known
Dynamic viscosity
3.37 mPa.s at 25 °C (77 °F)
None known
Other Information
Explosive properties
No information available
Oxidizing properties
No information available
Softening Point
No information available
Molecular Weight
No information available
VOC Content (%)
<50.0 g/L
Liquid Density
No information available
Bulk Density
No information available
Particle Size
No information available
Particle Size Distribution
No information available
10. STABILITY AND REACTIVITY
Reactivity
If stored and handled in accordance with standard industrial practices no hazardous
reactions are known.
Chemical stability
Stable under normal conditions.
Possibility of Hazardous Reactions
None under normal processing.
Hazardous Polymerization
Hazardous polymerization does not occur.
Conditions to avoid
None known based on information supplied.
Incompatible materials
Strong acids, strong bases, oxidizing agents.
Hazardous Decomposition Products
If stored and handled properly: none known. The following applies for the silicone content
of the substance: Measurements have shown the formation of small amounts of
formaldehyde at temperatures above about 150 °C (302 °F) through oxidation.