Use and Care Manual

Vital Coat Enhance & Seal Penetrating Sealer
Revision Date
_____________________________________________________________________________________________
_____________________________________________________________________________________________
1
Page 4 / 10
Specific hazards arising from the
chemical
Prevent firefighting run-off from entering drains or sewers.
Hazardous Combustion Products
Fires involving this product may release oxides of carbon and nitrogen, reactive
hydrocarbons, and irritating vapors.
Explosion Data
Sensitivity to Mechanical Impact
None.
Sensitivity to Static Discharge
None.
Special protective equipment for fire-
fighters
Firefighters should wear self-contained breathing apparatus and full firefighting turnout
gear. Use personal protection equipment.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Personal precautions
Secure the area. Wear personal protection equipment. Keep unprotected persons away.
Avoid contact with eyes and skin. Do not inhale gases/vapors/aerosols. If material is
released indicate risk of slipping. Do not walk through spilled material.
HAZWOPER PPE LEVEL: D
Methods and material for containment and cleaning up
Methods for containment
Prevent material from entering surface waters, drains or sewers and soil. Close leak if
possible without risk. Contain any fluid that
runs out using suitable material (e.g. earth).
Retain contaminated water/extinguishing water. Dispose of in prescribed marked
containers. Inform authorities if substance leaks into surface waters, sewerage or ground.
Spills of material which could reach su
rface waters must be reported to the United States
Coast Guard National Response Center's toll free phone number [phone].
Methods for cleaning up
Take up mechanically and dispose of per local/state/federal regulations. Do not flush away
with
water. For small amounts: Absorb with a neutral (non-acidic / non-basic) liquid
binding material such as diatomaceous earth and dispose of per government regulations.
For large amounts: Liquids may be recovered using suction devices or pumps. If
flammable,
only air driven or properly rated electrical equipment should be used. Clean
any slippery coating that remains using a detergent / soap solution or another
biodegradable cleaner. Silicone fluids are slippery; spills are a safety hazard. Apply sand
or other inert granular material to improve traction.
CAUTION: If spilled material is cleaned up using a regulated solvent, the resulting waste mixture will
also be regulated. Do not empty into drains. All disposal must comply with federal, state, and local
regulations. The material, if spilled or discarded, may be a regulated waste. Refer to state and local
regulations. Department of Transportation (DOT) regulations may apply for transporting this material
when spilled. See Section 14.
7. HANDLING AND STORAGE
Precautions for safe handling
Advice on safe handling
Precautions against fire and
explosion:
Avoid formation of aerosols. In case of aerosol formation special protective measures are
required (exhausting by suction,
respiratory protection). Spilled substance increases risk
of slipping. Observe information in section 8. Keep away from incompatible substances in
accordance with section 10.
Observe the general rules for fire prevention.