Use and Care Manual

3
STEP T WO
The Camden Privacy Screen
Equal Overhang
Slide the two post trim caps down the post as shown, followed
by the two post caps. The trim caps can sit on the horizontal rail
for now and the post cap pressure-fits into place.
Apply a small amount of glue to the inside of the end cap as
shown and insert onto the beam. Allow 30 seconds for the
glue to set and a few more minutes to cure.
Repeat for second beam.
With a helper, align one of the beam against the posts as shown.
The top of the beam should be at the same level as the bottom
of the post caps and the overhang should be equal on both ends.
1
2
3
4
1
2
4
Equal Overhang