Installation Guide

Louver Assembly
16
12 x 12 Flat Top Louvered Pergola
layout the twelve louver bars assemblies as shown below:
STEP S EVEN
Note:
The short louver bar assembly will be
packaged as such. You will need to
remove these two nuts and re-
position the short louver bar.
Note:
Reposition the short louver bar as shown but
do not bolt to the adjacent louver assembly at this point.
Important ! : the holes on the louver bars are offset. ensure
the holes are at the bottom as shown.
Note the distance to the first bolt;
the larger gap would go at the outside whereas
the smaller gap would go towards the middle bar assembly.
Ensure all brackets are facing
the same direction.
Do not re-attach nuts