Installation Guide

11
12 x 12 Flat Top Pergola
Rafter Assembly
Cut one 2x6x14 (5x15x427cm) down to 12’-6” (381cm) and Insert into
a rafter section followed by the joiner and another rafter section.
Make sure the 2x6x12’-6“ (381cm) wood is inserted about
1/8” (3mm) from the one end (the end that will be installed against
the wall), to accommodate the screw heads on the rafter hangers
Screw the joiner to vinyl rafters and wood insert using 1 1/2”
(38mm) screws.
Repeat steps 1 and 2 for the remainder of the rafters.
1
2
3
STEP SIX
Main Support Beam Assembly
Repeat step 1 from the previous step.
Install the rafter hanger to the main beams using four
1 1/2” (38mm) screws. Follow the pre-drilled holes to identify
locations.
Screw the joiner to vinyl beams and wood insert using 1 1/2”
(38mm) screws.
1
2
3
STEP FIVE
2
3
1
2