Owner`s manual

.4)
c. Ozone Generator Monitor
If your spa is equipped with an ozone
generator, the actual ultraviolet iight from the
generator will cause the OZONE light on the
display to glow, indicating proper operation
of the generator.
USING THE SPA
A. Starting Jet 1
You can activate the first set of jets by
touchilig the JET 1 s'vVitch at any time. You
might notice that the FILTER light goes off
whenever the JET 1 light comes on. This is
because the filter function and the first set of
jets share a common motor. Touch the JET1
switch again to stop the jets and retum to nor"
mal filtering, or wait 30 minutes and the jets
will automatically turn themselves off .
D. Panel Loekout
If you wish to make the SELECTROr-J
panelchjld proof, you can deactivate al!
touch switches by pressing the UP switch,
the DO\'VN switch, and the UP swItch 8gain
in exact order. If you do the sequenoe suc.
cessfully, the LOCK light on the display will
begin flashing and no more switch inputs will
be accepted. You may unlock the panel by
repeating the exact sequence of UP/DOWNI
UP.
a. Starting -Jet 2
The second set of jets Is independent of
any other function and can be turned on and
off at any time by touching the JET 2 switch.
These jets will also turn themselves off after
30 minutes of use.
c. Starting Blower
Your spa is equipped w.ith a 3~spesd air
blower. The first touch of the BLOWER switch
starts the blower at its iiight)'st speed; a sec~
ond touch reduces t\'ie blower to medium
speed: a third touch reduces the blower to low
speed: and a fourth touch turns the blower off.
The blower will automatically stop after 30 mtn-
utes of use.
E. Overheat Protection
if a possibilIty of overheating is detected,
the display wIll show HlL.l (high limit} and the
heater wilt be disabled. After the water
temperature cools below 104 degrees, you
may reset the heater function by holding the
HEATER switch for 5 seconds. or until the
dfsplay returns to nannal. If the HILI mes-
sage returns. you should calf for service.
D. Turning on Llgh1
Your spa also has an underwater light with
two levels of brightness. The first touch of ttle
LIGHT switch turns the light on at full bright-
ness; a second touch reduces the light to half
brightness; and a third touch tums the light off.
If left on, the light will automatically tum itself
off after 6 hours.
NOTE: While heating the $pa of when the spa Is
not being used; keep the air controls closed.
F. Battery Backup
fn the event of a power out8:ge, your spa
wIll remember individual settlnt;s for ttme,
temperature. fi1ter hours and h&ater days for
over 30 minutes. In cases of extreme ejectri.
cal noise problems or nearby electrical
storms, the SELECTRON's internal computer
could be disturbed. If you suspect a problem
with the computer because of a stranga
display or perfonT1anca that is not normal,
disconnect the spa at your circuit breaker
and allow the battery to run down for at 1east
2 hours. The:: SELECTRON will automatically
clear its memory and return to its original
operation.
5)
SPECIAL FEATURES
A. Automatic Blower/purge and Jets Pump
At 1 :00 pm each day, the blower will
automatically run for 1 mirlute to circulate
potential stale water in the water lines. This
is a nomlsl function of the spa.
6}
ADD START-UP CHEMICALS
CarefuUy follow the directions and add
the start-up chemicals recommended to you
by your dealer. Contact your dealer to clarify
any questions you may have.
B. Freeze Protection
If the TEMPERATURE IN THE PLUtv1B.
ING of the spa approaches 40 degrees. th$
filter and jet pumps will automatically come
on and run for at least one minute. If this
doesn'{ raise U)e ten-Jperature enough. the
heater will come on and raise the water
temperature about 10 degrees.
7)
JET OPERATION
Your Vita Spa Is designed with a unique
jet system whrch allovys you to select a wide
variety of massage pattems~ Thefoltqwingi~
a description of the various types of jets and
their operation you may use to taIlor your spa
to your specific n;ltiSsage n~ed$.
7