Owner`s manual

SYMPTOM
PROBABLE CAUSE
SOLUTION
Spa inoperative
* Pov.;er Failure
outside of spa
* Spa side locked
* Check power source
Breaker and GFCI;
Reset breaker/GFCI.
Call Electrician if it
will not reset.
* Lockout light is
flashing. Unlock.
Display: HILI
Overheat
* Let water Temperature
cool down to 1 04F and
reset by hotding HEATER
switch for 5 seconds,
or until display returns
to normal. If HIU
message returns, call
for service.
Display: BJ2P
t"'ormal if .this occurs
at 1 :OOpm. If not, reset
system by turning
power to the spa off
for 2 hours.
Blower/Pump Purge
Display: FP
Freeze Protection
is on. .
Normal if temperature
is 40F. Call for service
if temperature is
above 60F.
Display: SS=O;
SS=S; LS=O;
LS=S
Multiple
Car! for Service.
Water not hot
* ,
Set heater to desired
setting and start the
filter by holding FIL TEA
switch down for 5 secs.
to start a 6~hour period.
* Not a heat day * Check heat day to make
sure today is a heat day.
If these two solutions do not solve t,ie problem, call for service.
NOTE: EXTREME ELECTRICAL '.~OISE PROBLEMS SUCH AS POWE;R SURGES OR NEARBY
ElecTRICAL STORMS COULD DISTURB THE SIELECTRON'S INTERNAL COMPUTER IN iHESAME
WAVAS YOUR HOME COMPUTER. IF YOu suspecT A PROBLEM WITH THE COMPUTER BECAUSE
OF A STRANGE D1SPLAY OR A PERFORMANCE THAT IS NOT NORMAL, BEFORE CALLING FOR
)EAVICE, DISCONNECT THE SPA BY TURNING OFF YOUR $RUKER AND ALLOW THE eAr:rERY
TO RuNDOWNFOA AT LEAST 2 HOURS. TURN THE powERaA:oKoN AND THE SEL.EqTRoN'wrLL
AUTOMATICAlly CLEAR ITS 'MEMORY AND RETURN TO fTS OAAGINAlOPERATlON. "fHIS 1SSIMlLAR
TO PUSHING THE ..ResET" BUTTON ON YOUR HOME COMPUTER. c : .
, .c "