Owner`s manual

5. Within 10 seconds the SIX PRE-SET

buttons will be re-programmed and the DISPLAY

WINDOW will read ‘Saved’ then ‘Ready’. If nothing

happens when the programming chip is fully inserted,

turn the chip in the opposite direction and try again.

6. Remove the programming chip and return

it to the original package.

7. Press one of the six PRE-SET buttons to reveal, in the

DISPLAY WINDOW, the name of the program/drink.*

8. Carefully place the Blending Station motor back into

the hole in the counter.

NOTE: If for any reason the programmed times are

incorrect, they can be reset to the original factory

settings following the instructions below.

Resetting the PRE-SET buttons to the original

factory settings

WARNING: Please read all steps before reprogramming. Reverting your

PRE-SET PROGRAM buttons to the original factory setting, will erase any

programming installed with a custom program chip.

1. Enter the OWNER CONTROLS (press the Vita-Mix Logo) ‘Mode’ will appear in the

display window. Press the PRE-SET buttons 1 and 6 then the display window will say

‘Count Temp Total’.

2. Press the Vita-Mix Logo two more times to reveal the instructions on resetting the

PRE-SET buttons.

3. Press and hold the #4 button until the DISPLAY WINDOW reads ‘Restoring Please Wait’.

The PRE-SET buttons are now reset to the original factory settings.

Custom

Programmed

Chip

In-Counter

Hole

*Your machines PRE-SET PROGRAM buttons function and times may be different then described in the

owners manual due to your machine being custom programmed.