Owner`s manual

Touch & Go
®
Blending Station
®
ON/OFF switch - Located on the side of the Motor Base the ON/OFF switch controls the
power to the machine. With the machine plugged in, switch the machine to ON to ready the
machine for blending.
START/STOP button - Pressing START/STOP once starts and runs the machine and turns
the blades. Press the START/STOP button again to stop the machine and the blades.
(NOTE: Pressing one of the PRE-SET PROGRAM buttons, while the motor is running,
will also stop the machine.)
SPEED CONTROL button - Press the ▲ button to gradually increase the speed of the
blades in increments of 1%, up to 100%. Press the ▼ button to gradually decrease the
speed of the blades in increments of 1%, down to 7%. SPEED CONTROL is used to set the
blending speed of the PULSE buttons (See Instructions, pg.15) and the START/STOP button
(See Instructions, pg. 16). NOTE: These settings will reset if the power is shut off.
PRE-SET PROGRAM* buttons - These buttons, numbered 1 thru 6, are pre-programmed
blending cycles designed for the most commonly made drinks. Depending on the viscosity of
the drink you are creating, pressing one of the six PRE-SET PROGRAM buttons will run the
machine for a full cycle. The machine will stop by itself when the cycle is complete. A cycle
varies in speed and length, see the Instructions on page 14 for a complete description of the
range of each PRE-SET button. Due to the difference of recipes, your results may vary. See
page 6 for information on Custom Programming these six buttons.
DISPLAY WINDOW-This area depending on what button is pressed,
displays a variety of operation messages. A ‘Ready’ message appears
when there is power to the machine.
Start/Stop
Speed Control
Six Factory Pre-Set
Programs
Owner Controls
High/Low Pulse
Display Window
C
ontrol Panel
READY
4
*Your machines PRE-SET PROGRAM buttons function and times may be different then described in the
owners manual due to your machine being custom programmed.