Owner`s manual

32
© Vita-Mix Corporation – Appendix C: Programming a Blender with a Programmer Chip
Appendix C:
Programming a Blender with a
Programmer Chip
Insert the Programmer Chip firmly into the
blender Programmer Port. The words, THIS SIDE
FACING TO THE FRONT OF THE MACHINE
must be facing you. NOTE: Reference the product
Owner’s Manual for the exact location of the
Programmer Port.
a) The DISPLAY WINDOW on blenders with
digital displays will read NEW MODULE.
b) Within 10 seconds, the DISPLAY WINDOW
on blenders with digital displays will read
SAVED, then READY. If this does not
happen, remove the chip, turn it over over,
and try again. If the problem persists, try re-
setting the blender controls a second time.
c) Remove the Programmer Chip from the
Programmer Port and return it to the original packaging.
If the preceding does not work,
reset the blender buttons to orginal factory settings.
WARNING:
resetting will erase any custom programs saved in the blender memory.
To save programs before resetting, see
To Load from a Programmer, page 22.
For Vita-Mix blenders with digital displays:
a) Press the Shift Button on the blender control panel to
access OWNER CONTROLS.
b) When the the display reads MODE:
On
Vita-Mix
®
PBS Portion Blending Systems
®
, press PRE-SET
Button 1, then PRE-SET Button B.
On Vita-Mix Blending Stations
®
, press PRE-SET button 1, then PRE-
SET button 6.
c) Next, access the instructions for resetting the PRE-SET buttons:
On
Vita-Mix PBS Portion Blending Systems, press the Shift Button
three times.
On Vita-Mix Blending Stations, press the Shift Button twice.
d) Finally, press and hold the #4 Button until the DISPLAY WINDOW
reads RESTORING PLEASE WAIT.