Owner`s manual

23
© Vita-Mix Corporation – How to Program a Blender
How to Program a Blender(
continued)
To Program a Blender:
Plug a chip into the blender (see
Appendix C: Programming a Blender
with a Programmer Chip for details).
OR
Insert the Programmer Module into the blender Programmer Port (see
Appendix B: Working with the Programmer Module for location).
a)The DISPLAY WINDOW on blenders with digital displays will read NEW
MODULE.
b)Click on the program blender button* in the Programmer Window.
c)The following dialog boxes will displayed on blenders with digital displays.
d)Within 10 seconds, the DISPLAY will read SAVED, then READY.
e)Remove the Programmer Module from the Programmer Port.
If the preceding does not work, then
reset the blender buttons to original
factory settings
.
WARNING: resetting will erase any custom programs saved in the
blender memory. To save programs before resetting, see To Load from a
Programmer, page 22.
For Vita-Mix blenders with digital displays:
a) Press the Shift Button on the blender control panel to
access OWNER CONTROLS.
b) When the the display reads MODE:
On
Vita-Mix
®
PBS Portion Blending Systems
®
, press PRE-SET
Button 1, then PRE-SET Button B.
On Vita-Mix Blending Stations
®
, press PRE-SET button 1, then PRE-
SET button 6.
c) Next, access the instructions for resetting the PRE-SET buttons:
On
Vita-Mix PBS Portion Blending Systems, press the Shift Button
three times.
On Vita-Mix Blending Stations, press the Shift Button twice.
(continued on next page)