User`s manual

3.2 Turning on the Power
Once the above hardware is properly connected, it is the time to turn on the GV-Hot Swap DVR V2. To
turn on the power, follow these steps:
1. Turn on the monitor.
On
Figure 7
2. Turn on the AC power switch on the rear panel.
Power On
Figure 8
3. Turn on the main power switch on the front panel.
Power On
Figure 9
The GV-Hot Swap DVR V2 will run a series of self-tests. After two or three minutes, a series of
messages may be displayed as the various hardware and software subsystems are activated. After this
is finished, the GV-System Software (Multicam Surveillance System) should load automatically and
bring you to the main screen with 8 or 16 cameras display.
14