User`s manual

User’s Manual

www.dynacolor.com.tw

5.8 Configuration >

The Configuration menu can be used to restore the default factory settings,

import and export configuration.

Select <Configuration> from the Main menu and press ENTER. The following

menu is displayed.

Configuration

1. Load Factory Default

2. Import Config

3. Export Config

Items in this menu are described in the following subsections.

5.8.1 Load Factory Default >

This item is used to load the factory setting; select <YES> to recall the factory

default setup configuration from the read-only memory, or <NO> to cancel.

5.8.2 Import Configuration >

This item allows user to load a unit configuration that was saved in an

external drive. To import a configuration that was previously exported, make

sure the device that saved the configuration is connected to the unit. Select

<Import Config> from the Configuration menu and press ENTER. The

following menu is displayed.

Import Config

Config Name

xxxx-xxxx

xxx-xx

Select

Press UP / DOWN to select one of the listed available configuration files, and

choose <YES> to start import.

NOTE: If the imported configuration has different record mode from

the unit’s, the warning message “This config has different record

mode. This will FORMAT ALL HARDDISKS.” will show.

NOTE: Remove the ThumbDrive

used for importing configuration

after the unit restarts, or it will be formatted as well.