User`s manual

User’s Manual

www.dynacolor.com.tw

5.6.4.5 Alarm In >

This item allows user to enable / disable alarm input detection. According to

your application, select <N/O> (Normal Open) or <N/C> (Normal Close) to

enable the alarm input detection or select <OFF> to disable the detection.

The default setting is <OFF>.

If you set this item to <N/C> but did not install any device to the unit, the

alarm will be triggered and the Event Icon displayed continually until this item

is changed to <N/O>, <OFF> or install a device to the unit.

5.6.4.6 Alarm Out >

This item allows user to assign an alarm on certain channel to activate the

relays. These signals can be used to drive a light or siren to caution an alarm

event.

Select from the options: <A Only > indicates “Alarm Out A”, <B Only>

indicates “Alarm Out B”, <A+B> indicates “A and B Alarm Out” and <None>

indicates “No Alarm Out”. The default setting is <None>.

5.7 Database Setup >

The menu displays information of internal and external disks. In the Main

menu, move the cursor to <Database Setup> and press ENTER. The

following menu is displayed.

Database Setup

1. Total Size

2. Free Size

3. Avail REC Time

4. Internal Disks

5. External Disks

xxx GB

3Days 7Hrs

NOTE: If the hard disk is failed detected, the message “HDD fail”

will display.

5.7.1 Total / Free Size of HDD >

The Total Size of HDD shows the total capacity of HDD that has been added

into database. The Free Size of HDD indicates the free space for recording of

the HDD added in database. The information is read-only.