User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
70
- Detected Area Setup >
The Detect Area is displayed as follows after selecting this item. The
detection area consists of 273 (21×13) detection grids in NTSC video format
or 336 (21×16) grids in PAL format.
■
■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■
Use the Direction keys to move the cursor and press ENTER to enable or
disable a grid. Press MODE to select all of the grids for detection; press
MODE again to de-select all of the grids.
- Sensitivity >
The item is used to set the sensitivity of detection grids for the camera. A
greater value indicates more sensitive motion detection. A motion alarm will
be triggered, once the amount of motion detected exceeds the Threshold
value
Move the cursor to <Sensitivity> and press ENTER, and then use UP /
DOWN keys to adjust the value. The value is indicated in 4% increment.
- Area Threshold >
<Area Threshold> means the motion alarm triggered level; if the percentage
of triggered grids to total detection area is greater than the set value, the
motion alarm will be triggered.
For example, if 10 grids are selected and the < Area Threshold > value is
70%, the motion alarm will be triggered when 7 grids are motion detected.
Move the cursor to < Area Threshold > and press ENTER, and then use UP /
DOWN keys to adjust the value. The value is indicated in 4% increment.
- Detected Area Percentage >
The part shows the percentage and variation of the detected volume.