User`s manual

User’s Manual

www.dynacolor.com.tw

Follow these steps to set a sequence:

• Press LEFT direction key to delete the original setting.

• Press the desired Channel keys to assign a camera to that location in the

sequence.

• Continue the steps until the sequence is completed.

A sequence can have up to 16 entries. User can select fewer than 16 entries

for camera sequence and leave the remaining entries blank. The sequence

can include a specific camera or cameras multiple times.

5.6 Event Setup >

This menu allows user to determine DynaGuard

100 MPEG-4 DVR

behavior in response to an alarm event. In the Main menu, move the cursor

to <Event Setup> and press ENTER. The following menu is displayed.

Event Setup

1. Internal Buzzer

2. Event Icon

3. Event Full Alarm

4. Event Duration

5. Per Channel Config

OFF

5 sec

Items in the Event Setup menu are described in the following subsections.

5.6.1 Internal Buzzer >

This item allows user to enable / disable the DynaGuard

100 sMPEG-4

DVR internal buzzer. If set to <ON>, the buzzer is activated in response to an

alarm. If set to <OFF>, the buzzer is not activated. The default setting is

<ON>.