User`s manual

User’s Manual

www.dynacolor.com.tw

5.4.4 ezRecord Setup >

This item aims to avoid the complicated record settings, and to make the

setup much easier. Note that the item can be reached only when you select

<ezRecord> as the option for <Preset Config>.

Select <ezRecord Setup> from <Record Setup> and press ENTER, the

sub-menu appears as below figure:

ezRecord Setup

How Many Days To Record

Daytime Record

Night Record

Weekend Record

The Quality will Be

2 Days

Yes

Fair

To have the ezRecord Setup done, follow these steps:

• Select <How Many Days To Record> and press ENTER, then press

UP/DOWN to choose the option you want. The maximum of days

depends of the size of your HDD, in the other words, the larger the HDD

installed, the more days the unit can record.

• Move to <Daytime Record> and press ENTER. This item is for you to

select whether you want the DVR to record during daytime. If yes, using

UP/DOWN to select <Yes> as option; or, select <No> for not recording

during daytime.

• Repeat the same procedures through the 3rd and 4th item, respectively.

Note that <Weekend Record> will be not accessible if you select <NO> for

the item <Weekend Schedule> in <Schedule Setup>.

• According to upper item you have set, the quality will be automatically

accounted and shown on the screen. This item is for read-only. Five

options, including <Best>, <High>, <Mid>, <Fair> and <Low>, you may

see on this item. We strongly recommend to keep the quality higher than

“Middle”.

NOTE: The current number of connected cameras will affect the

recording quality automatically calculated through the <ezRecord

Setup>. Therefore, once you disconnect cameras or connect more

cameras to the unit, you should reset the <ezRecord Setup>.