User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
61
5.4.1 Record Mode >
The item is for selecting resolution and recording rate. The relative record
settings, such as preset configuration, will follow the record mode setting.
The options are <720 × 480@30PPS>, <720 × 240@60PPS> and <360 ×
240@120PPS> in NTSC (<720×576@25PPS>, <720×288@50PPS>, <360×
288@100PPS>in PAL).
Move the cursor to this item and press ENTER, then select a Record mode
using UP / DOWN keys.
NOTE: After changing the Record Mode setting, the warning
message “This will FORMAT ALL HARDDISKS and LOAD THE
FACTORY DEFAULT CONFIG!” will be shown on the screen. Press ENTER
to confirm the selection, then the unit starts to format the hard disks and load
the factory default settings, or press ESC to abort. We strongly recommend to
backup your programmed configuration before making any changes on
Record Mode settings.
5.4.2 Schedule Setup >
This submenu is used to set the day and night time, or weekend recording
schedule.
The Night and Day schedules are used to define daytime and nighttime; the
Weekend schedule is tailored for weekends and holidays.
Select <Schedule Setup> from the Record Setup menu and press ENTER;
the following menu is displayed.
Schedule Setup
1. Day Time Start
2. Night Time Start
3. Weekend Schedule
4. Weekend Start
5. Weekend End
06:00
18:00
YES
Fri 18:00
Mon 06:00
5.4.2.1 Day / Night Time Start >
The Day/Night Start Time determines the beginning of day/night recording
time. Time is indicated in 1-minute increments. The time display format in this
menu is based on the setting of Time Display Mode.