User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
57
5.2.7 VGA Resolution >
The item allows user to select appropriate VGA resolution for the VGA
monitor connected to the unit. The options are <800×600> (default), <1024×
768> and <1280× 1024>.
NOTE: If the selected VGA resolution is too high for the monitor, the
message “No Signal’’ will be shown on screen. Then please press
ESC on the front panel to restore the original setting.
5.3 Camera Setup >
The items in the Camera Setup menu enable user to set camera parameters,
including camera title, dome protocol and ID for each connected camera. The
menu is shown as below.
Camera Setup
1. Camera Select
2. Dome Protocol
3. Dome ID
4. Camera Title
5. Covert
6. Termination
7. Brightness
8. Contrast
9. Saturation
10. Hue
CH1
None
0
CH1
NO
NO
0
0
0
0
Items in this menu are described in the following subsections.
5.3.1 Camera Select >
The item is used to select a camera for setting the parameters. The related
settings will follow the selected camera, such as dome protocol and camera
title.
Move the cursor to <Camera Select> and press ENTER, then select a
channel using UP / DOWN keys.