User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
54
- Connect At Booting >
The unit is allowed to connect to the internet automatically when powered up.
Select <YES> to connect at booting, otherwise select <NO>. The default
setting is <YES>.
- Network Restart >
Network restart is required after changing network settings. Select <YES> to
restart the network device.
5.1.6.2 Trigger Port >
To avoid the default service port (port 80) to be blocked, the item enables
user to change port 80 into another port.
To change the trigger port, move the cursor over <Trigger Port> and press
ENTER, then adjust the setting by UP / DOWN keys.
5.1.7 RS485 Setup >
This menu allows setting up the parameters of the unit’s RS-485
communications port. From the Main menu, select <RS485 Setup> and press
ENTER. The following menu is displayed.
RS485 Setup
1. Unit ID
2. Baud Rate
3. Bits
4. Stop
5. Parity
224
9600
8
1
None
5.1.7.1 Unit ID >
This item is used to change the RS-485 ID address of the unit. The ID is in
the range of <1> to <255>. The default is <224>.
5.1.7.2 Baud Rate >
The Baud rate options for associated with the protocol are <2400>, <4800>,
<9600>, <19200> and <38400>. The default is <9600> baud.