User`s manual

User’s Manual

www.dynacolor.com.tw

From the System Setup menu, select <Network Setup> and press ENTER.

The following menu displays.

Network Setup

1. LAN Setup

2. Trigger Port

Items in this menu are described in the following sections.

5.1.6.1 LAN Setup >

The network related settings in the LAN Setup menu should be associated

with the network service type.

Select <LAN Setup> in Network Setup menu and press ENTER for setting

the parameters; the menu displays as follows.

LAN Setup

1. DHCP

2. IP

3. Netmask

4. Gateway

5. DNS

6. Connect At Booting

7. Network Restart

xxx.xxx.xxx.xxx

YES

- DHCP >

This item allows user to obtain a dynamic IP address from DHCP (Dynamic

Host Configuration Protocol) server during the unit boots up. When using

DHCP, the settings are dynamic and they will change every time you power

up and power off the unit; depending on your network's setup.

If the item is enabled (ON), a dynamic IP will be assigned to DynaGuard

100 MPEG-4 DVR. In this case, user does not need to configure a static IP

and the Ethernet settings including IP address, Netmask, Gateway, and DNS

settings will be read-only. The default setting is <ON>.

If you are using permanent addressing, set DHCP to <OFF> for setting the IP

Address, Netmask, Gateway, and DNS. See your network system

administrators or IT personnel for appropriate values for these settings.