User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
51
5.1.5.1 Admin / User Password >
Only the administrator is allowed to change the user and administrator
password to any 4~8 digit number. Use the UP / DOWN Direction keys to
select the desired account and press ENTER, the following menu is
displayed.
Admin Password
________
Press Channel Keys To Enter Password
(4-8 Digits)
Press ◄ To Delete
Use CHANNEL keys to input the new password and confirm the new
password. After setting the new password, press ENTER to save the settings
and exit.
5.1.5.2 Enable Password >
The item is used to determine if the password is required for accessing the
OSD menu. Select <YES> to demand entering password when accessing the
OSD menu; if not, select <NO>.
5.1.5.3 Load Factory Password >
This item allows the administrator to reload the factory password in case that
the administrator cannot remember the password. There are three options to
select from: <Admin> (reload the Admin password only), <User> (reload the
User password only), and <All> (reload the Admin and User passwords). The
factory password is 1234 for administrator and 4321 for user.
5.1.6 Network Setup >
The Network Setup menu allows the administrator to configure the network
by specifying the network related settings, such as IP address and Netmask,
etc.
See your network administrator and/or network service provider for more
specific information.