User`s manual

User’s Manual
www.dynacolor.com.tw
All rights reserved
32
4.2.1 Sequence with Main Monitor
Automatic sequence function can be used in any view mode with the Main
Monitor. Select certain view format and press SEQ to toggle the automatic
sequential sequence, press ESC to stop sequencing. The figure below
displays the 4-camera sequencing view modes.
To assign cameras to certain sequence, refer to Section 5.5.2 Main/ Call
Monitor Schedule.
4.2.2 Sequence with Call Monitor
Users are allowed to use the DynaGuard
TM
100 MPEG-4 DVR front panel to
control a call monitor display without having to access the Main menu. Two
viewing modes can be displayed on call monitor: Sequence display and
Single camera display. To program the call monitor sequence, see section 5.5
Sequence Setup.
Follow the steps to control the call monitor.
• Press the CALL key on the front panel to enter call monitor control mode,
the message “Call Mode” will be shown on the bottom-left of the screen.
Press 1-8 Key To Select Channel
Press SEQ To Enable Sequence
Call Mode
• Press CHANNEL key to display the associated camera on call monitor.
• Alternatively, press SEQ repeatedly to display the sequence of cameras
previously programmed in Call Monitor Schedule menu.
• Press ESC to return the front panel to Main monitor control mode.