User`s manual

User’s Manual

www.dynacolor.com.tw

DST Bias

The item allows user to set the amount of time to move forward from the

standard time for daylight saving time. The available options are <30>, <60>,

<90> and <120> minutes.

3.5 Record Schedule / Quality Setting

The Record Setup menu allows user to set recording quality, recording

schedules, and other recording parameters. Administrator's password is

required to use Record Setup menu. In the Main menu, move the cursor to

<Record Setup> and press ENTER; the following menu is displayed.

Record Setup

1. Record Mode

2. Schedule Setup

3. Preset Config

4. ezRecord Setup

5. Circular Recording

6. Purge Data

720×240@60PPS

Standard

3.5.1 Record Mode

The Record Mode is for selecting resolution and recording rate. The relative

record settings, such as preset configuration, will follow the record mode

setting. In normal circumstance, we recommend you to select

<720x240@60PPS>, the default, for this item.

Move the cursor to <Record Mode> and press ENTER, then select a Record

mode using UP / DOWN keys.

NOTE: After changing the Record Mode setting, the warning

message “This will FORMAT ALL HARDDISKS and LOAD THE

FACTORY DEFAULT CONFIG!” will be shown on the screen. Press

ENTER to confirm the selection, then the unit starts to format the hard

disks and load the factory default settings, or press ESC to abort.

We strongly recommend to backup your programmed configuration

before making any changes on Record Mode settings.