User`s manual

User’s Manual

www.dynacolor.com.tw

3.2 Power Up / Down the Unit

If you must shut down the DynaGuard

100 MPEG-4 DVR for any reason,

please use the proper shut down and power up procedures to avoid

damaging your DVR unit.

To Power Up the Unit

Check the used type of power source before plug in your DVR first (the unit

accepts the power input between AC110V to AC240V), and turn on the unit

using the power switch on the rear panel.

The color bar and system checking information will be shown on the monitor

and disappear when the unit has been completely powered up.

To Restart / Shutdown the Unit

Press MENU and input the administrator password to access the OSD Main

menu. Select <Shutdown> in Main Menu and press ENTER to enter the

Shutdown menu, which displays as follows.

Shutdown

1. Power Off

2. Reboot

Select this item to shut down the unit. Do not remove the power during

shut down until the message “You can safely turn off DVR now!”

displays.

Select this item to reboot the unit. The color bar and system checking

information are displayed on the monitor until the unit is completely

restarted.