User`s manual

User’s Manual

www.dynacolor.com.tw

2. Unit Installations

The notices and introduction on system installation will be described

particularly in this chapter. Please follow the description to operate the unit.

In order to prevent the unit from data loss and system damage that caused by

a sudden power fluctuation, use of an Uninterruptible Power Supply (UPS) is

highly recommended

2.1 Position the Unit

Firstly, note to position / mount the DynaGuard

100 MPEG-4 DVR in a

proper place and be sure to power off the unit before making any connections.

The placed location should avoid hindering or blocking the unit from airflow.

Enough airflow is needed to protect the unit from overheating. The maximum

allowable temperature of operating environment is 40°C.

The unit utilizes heat-conducting techniques to transfer internal heat to the

case, especially to the bottom side of the unit.

NOTE: Be sure not to remove the rubber feet, and always leave a

space for air ventilation on the unit’s bottom side.

2.2 Selecting Video Format

The DynaGuard

100 MPEG-4 DVR is designed to operate under either

NTSC or PAL video formats. The switch is positioned on the rear panel.

2.3 Connecting Devices to the Unit

This section lists some notices that should be given before making any

connections to the DynaGuard

100 MPEG-4 DVR.

NOTE: Connect short-term devices, such as USB ThumbDrive

USB CD-ROM, USB Hard Disk Drive, etc., only after the unit is

successfully powered up.