Installation Sheet

SS 4016

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (A) from ﬁxture base (D) by unscrewing cap nuts (F) and set aside.

2. Afﬁx mounting plate (A) onto ceiling outlet box and secure with mounting screws (C).

3. Connect ground wire from the light ﬁxture (bare copper) to ground wire from ceiling outlet box (usually green or

copper in color). Fasten together with a plastic wire connector provided and tightly wrap the wire connector with

electrical tape so the end of the connector is sealed. IT IS IMPERATIVE THAT THE OU1LET BOX IN YOUR HOME

BE PROPERLY GROUNDED.

4. Connect both hot wires from the ﬁxture (BLACK) to the hot junction box wire from ceiling outlet box (usually

BLACK). Fasten together with a plastic wire connector provided and tightly wrap wire connector with electrical tape.

5. Repeat this procedure for the WHITE neutral wires from the light ﬁxture to the wire from ceiling outlet box (usually

WHITE). DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE

COMPROMISED.

6. Attach ﬁxture base (D) to afﬁxed mounting plate (A), letting rods (B) pass through the holes on ﬁxture base (D), and

secure with cap nuts (F).

7. Insert light bulbs into sockets.

8. Loosen thumbscrews (E) and attach glass shade (G) to ﬁxture base (D) by aligning the holes of ﬁxture base (D) with

glass shade (G) and tighten with thumbscrews (E).