Installation Sheet

SS4010

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (A) from ﬁxture base (D) by unscrewing cap nuts (E).

2. Attach mounting plate (A) to the ceiling outlet box and secure with mounting screws (B).

3. Attach top nipple of rod (F) to the ﬁxture base (D), letting rod (F) pass through the center hole of ﬁxture base (D)

and secure with hex nut (C).

4. Connect the ground wire from ﬁxture base (bare copper) to the ground wire from the outlet box (usually green

or copper in color).Fasten together with a plastic wire connector provided and tightly wrap the wire connector with

electrical tape so the end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME

BE PROPERLY GROUNDED.

5. Connect both neutral (white) ﬁxture wires coming from the ﬁxture base to the neutral (usually white) outlet wire.

Fasten both wires together with a plastic wire connector and tightly wrap the wire connector with electrical tape.

6. Repeat this procedure with the hot (black) wires. Always make sure that no wire strands are left outside the

connector. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED

Attach ﬁxture base (D) to afﬁxed mounting plate (A), letting threaded rods on mounting plate (A) pass through both

holes of ﬁxture base (D) and secure with cap nuts (E).

7. Insert light bulbs into sockets.

8. Remove ﬁnial (H) from bottom of rod (F) and attached glass shade (G) to ﬁxture base (C), letting rod (D) pass

through the center hole of glass shade (G) and secure with cap nut (H).

DO NOT OVER TIGHTEN, OTHERWISE IT WILL CAUSE GLASS TO BE BROKEN.