Installation Sheet

1. Carefully remove all parts from the box.
2. Remove the mounting plate (B) from the fixture (E) by loosening the finials (G).
3. Affix mounting plate (B) to the outlet box and secure with mounting screws (D).
4. Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box
(usually BLACK). Fasten them together with a plastic wire connector (A) provided and
wrap the connection with electrical tape.
5. Repeat this procedure for the neutral wire (WHITE) from the fixture to the wire from the
outlet box (usually WHITE).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
6. Connect ground wire from the fixture (bare copper) to ground wire from the outlet box
(usually green or copper in color).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Unscrew the round plate (I) from the fixture (E).
8. Attach the glass diffuser (H) onto the round plate (I).
9. Attach the fixture (E) onto the mounting plate (B). Let screws (C) pass through the holes
on the top of fixture, and secure with finials (G).
10. Insert bulbs (not included) into the sockets.
11. Attach the assembled round plate (I) to the fixture bottom and secure with screws (J).
12. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Do not use harsh abrasives or chemical agents.
Sophie Flush Mount
Item # NW 4020
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIALLY UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP