Installation Sheet
1. Carefully remove all parts from the box.
2. Remove mounting plate (C) from the canopy (G) by loosening the side screws (H).
3. Put the mounting plate (C) on the ceiling and mark the anhor holes position with pencil.
4. Drill 4 holes on the wall and knock the anchors (B) into the holes.
5. Affix mounting plate (C) onto the junction box and secure with mounting screws (D), then
secure the wood screws (E) to the anchors (B) and lock tight.
6. Attach the alabaster holder (I) with the alabaster shade (J) to the canopy (G) and secure
with lock nuts (F).
7. Connect ground wire from the fixture (bare copper) to ground wire from the junction box
(usually green or copper in color) using wire nut (A).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
8. Connect the neutral wire (WHITE) from the fixture to the neutral wire (White) from the
junction box using wire nut (A).
9. Connect the hot wire (BLACK) from the fixture to the hot wire (Black) from the junction
box using wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
10. Attach the canopy (G) to the mounting plate (C) and secure with side screws (H).
11. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Covet Medium Flush Mount
Item # KW 4113
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
L
I
S
T
E
D
C
US
Intertek
CM
TO assemble safety cables:
1.Join fixture safety cables with safety
cable from ceiling.
2.Wrap both safety cable around the
cable lock nut.
3.Insert screws into both holes on cable
lock nut,secure screws with screwdriver.
4.Push the cable lock nut into outlet box.
Safety cable
Cable lock nu
t
junction box