Installation Sheet

1. Carefully remove all parts from the box.
2. Attach the alabaster disk (F) to the bracket (H) and secure with screws (G).
3. Thread the tube (J) to the metal part (I).
4. Remove the mounting plate (B) from the canopy (D) by loosening the side screws (E).
5. Affix the mounting plate (B) onto the junction box and secure with mounting screws (C).
6. Connect ground wire from the fixture (bare copper) to ground wire from the junction box
(usually green or copper in color) using wire nut (A).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the neutral wire (WHITE) from the fixture to the neutral wire (White) from the
junction box using wire nut (A).
8. Connect the hot wire (BLACK) from the fixture to the hot wire (Black) from the junction
box using wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
9. Attach the canopy (D) to the mounting plate (B) and secure with side screws (E).
10. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Melange Large Floating Disc Semi-Flush Chandelier
Item # KW 4015
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
L
I
S
T
E
D
C
US
Intertek
CM
H
G
F
junction box
A
B
E
C
D
I
J

Summary of content (1 pages)