Installation Sheet

ASSEMBLY INSTRUCTIONS Melange Small Flush Mount Lamp
Item # KW4012
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL, IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
U
L
DAMP
1. Carefully remove all parts from the box.
2. Remove the mounting plate (B) from the fixture by loosening the finial (G).
3. Affix mounting plate (B) onto the outlet box and secure with mounting screws (D).
4. Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box
(usually BLACK). Fasten them together with a plastic wire connector (A) provided and
wrap the connection with electrical tape.
5. Repeat this procedure for the neutral wire (WHITE) ) from the fixture to the wire from
the outlet box (usually WHITE).
6. Connect ground wire from the fixture (bare copper) to ground wire from the outlet box
(usually green or copper in color).
7.
8. Remove the screw(E) from the part(F)then open it.
.
10. Install the alabaster(H)to the bottom of the part(F)and secure tightly with screw(E).
11.
Attach the fixture onto the mounting plate (B), let screws (C) pass through the holes on
the top of the fixture, and secure with finial (G).
9
Insert bulbs (not included)into the socket.
Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Do not use harsh abrasives or chemical agents.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
COMPROMISED.