Installation Sheet
.
DAMP
1. Carefully remove all parts from the carton.
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED
ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
2. Remove mounting plate (B) from fixture base (E) by removing base screws (F).
3. Position mounting plate (B) on the ceiling outlet box. Mark center points for mounting
holes with a pencil on the ceiling. Remove mounting plate (B).
4. Drill small holes on each point location on the ceiling, each hole should be large enough to
accommodate to the plastic anchor (A). Push plastic anchors (A) into the holes in the ceiling.
5. Affix mounting plate (B) to ceiling oultet box, aligning holes and secure by inserting mounting
screws (D) to the holes of outlet box and screws (C) to the plastic anchors (A) in the ceiling.
6. Gently pull the wires from the ceiling outle and allow the wires to hang. Thread the wires
through the center hole in moutning plate (B).
7. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper
in color ), fasten together with a plastic wire connector. Tightly wrap the wire with electrical
tape. so the end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX
IN YOUR HOME BE PROPERLY GROUNDED.
8. Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white )
outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the
wire connector with electrical tape.
9. Repeat the procedure with the hot (black) wire. Always make sure that no wire strands are
left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS
OTHERWISE SAFETY WILL BE COMPROMISED.
10. Attach fixture base (E) to mounting plate (B) and secure by inserting base screws (F).
11. Remove cap nuts (G) from fixture base (E), attach shade (H) to fixrture base (E), let the rods
on side of fixture base (E) pass through the holes on shade (H) and secure with cap nuts (G).
12. Insert light bulbs into sockets.
13. Remove finial (J) from the center nipple of fixture base (E), attach diffuser (I) to the bottom of
shade (H), let the center nipple of fixture base (E) pass through the hole of diffuser (I) and secure
with finial (J). Tighten by hand.
14. Restore power and test fixture. Installation is complete.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Bryce Medium Flush Mount
Item # KS 4117
ASSEMBLY INSTRUCTIONS
H
I
J
F
C
B
A
D
E
G
N
E
W
Y
O
R
K
spad
e
k
a
t
e