Installation Sheet

1. Carefully remove all parts from the box.
2. Remove the mounting plate (C) from the canopy (E) by loosening the side screws (D).
3. Affix mounting plate (C) onto the outlet box and secure with mounting screws (B).
4. Thread the crystal flowers (G) to the ball (F).
5. Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box
(usually BLACK). Fasten them together with a plastic wire connector (A) provided
and wrap the connection with electrical tape.
6. Connect the neutral wire (WHITE) from the fixture to the wire from the outlet box
(usually WHITE).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
7. Connect ground wire from the fixture (bare copper) to ground wire from the outlet box
(usually green or copper in color).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
8. Attach the canopy (E) onto the mounting plate (C) and secure with side screws (D).
9. Insert bulbs (not included) into the sockets.
10. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Do not use harsh abrasives or chemical agents.
Dickinson Medium Semi-Flush
Item # KS 4005
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIALLY UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
kate spade
NEW YORK
TO assemble safety cables:
1.Join fixture safety cables with safety
cable from ceiling.
2.Wrap both safety cable around the
cable lock nut.
3.Insert screws into both holes on cable
lock nut,secure screws with screw driver.
4.Push the cable lock nut into outlet box.