Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove back plate (B) from base of light ﬁxture (E) by removing base screws

(F) incounter-clockwise direction.

3. Position back plate (B) horizontally or vertilcally on the wall outlet box. Mark

center points for both mounting holes with a pencil. Remove back plate (B).

4. Drill small holes on each point location on the wall, each hole should be large

enough to accomodate the plastic anchor (A). Push plastic anchors (A) into the

holes in the wall.

5. Gently pull the wires form the wall outle and allow the wires to hang. Thread the

wires through the center hole in back plate (B).

6. Attach ground (green) wire to ground wire from wall outlet box (usually green or

copper in color), fasten together with a plastic wire connector. Tighten wrap the

wire with electrical tape. so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

7. Connect neutral (white ) ﬁxture wire coming from ﬁxture base to neutral (usually

white) outlet wire. Fasten both wires together with a plastic wire connector and

tightly wrap the wire conncetor with electrical tape.

8. Repeat the procedure with the hot (black) wires. Always make sure that no wire

strands are left outside the connectors.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE

SAFETY WILL BE COMPROMISED.

Keaton 36” Floral Vanity Light

Item # KS2233

DAM P

PAGE 1
Keaton 36” Floral Vanity Light Item # KS2233 ASSEMBLY INSTRUCTIONS WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. F ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. Carefully remove all parts from the carton. 2.
PAGE 2
Keaton 36” Floral Vanity Light Item # KS2233 ASSEMBLY INSTRUCTIONS WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. F ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1.