Specification Sheet

1. Carefully remove all parts from the box.
2. Put the mounting plate (C) on the ceiling and mark the holes position with pencil.
3. Drill 4 holes on the ceiling and knock the anchors (B) into the holes.
4. Affix mounting plate () onto the junction box and secure with mounting screws (D), then
secure the wood screws (E) to the anchors (B) and lock tight.
5. Thread the ceiling loop (F) to the mounting plate (C) until tight.
6. Put canopy (G) flush to the ceiling, and secure with collar ring (H).
7. With the fixture desired height, shorten the chain (I) as needed using a pair of chain
pliers.
8. Open the chain quick link, then attach the chain quick link to the ceiling loop (F). Secure
the chain quick link.
9. Open the chain quick link, then attach the chain quick link to the fixture top loop (J).
Secure the chain quick link.
10. Weave the power supply cord and the ground wire through the chain (I).
11. When you reach the canopy and collar loop (F), measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
12. Strip the insulation back on the two power supply wires about 5/8".
13. Loosen the collar ring (H) and let the canopy (G) slip down the chain carefully.
14. Twist the power supply and ground wire together and push through the center hole of
the collar loop (F).
Illana Large Linear Chandelier
Item # JN 5630
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DRY