Installation & Assembly
SL2934
ASSEMBLY & INSTALLATION GUIDE
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT
BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove back plate (A) from the base of lighting fixture (B) by unscrewing base screws (C) in counter- clockwise
direction.
2. Affix back plate (A) to wall outlet box with back plate screws (D) provided.
3. Attach ground (green) fixture wire to ground wire from wall outlet box (usually green or copper in color), and
fasten together with a plastic wire connector. Tightly wrap the wire connector with electrical tape so the end of the
connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
4. Connect the neutral (RIBBED, without any marking) fixture wire to the neutral (usually white) wire from with electrical
tape.
5. Repeat the procedure with the hot (ROUND, with UL marking on) wires. Always make sure that no wire strands are
left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
6. Attach fixture base (B) to back plate (A) and tighten with base screws (C).
7. Remove socket ring (G) from socket (E), place glass shade (F) over the socket and tighten with socket ring (G).
8. Insert light bulb into socket.
(A)
(D)
(B)
(C)
(E)
(F)
(G)
9. Insert light bulb Type A, maximum 60 watt into socket.
7. Attach fixture base (B) to back plate (A) and tighten with base screws (C).
OR SAFETY WILL BE COMPROMISED.
with electrical tape.
PROPERLY GROUNDED.
clockwise direction.
5. Connect the neutral (RIBBED, without any marking) fixture wire to the neutral (usually white) wire from
end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
2. Remove back plate (A) from the base of lighting fixture (B) by unscrewing base screws (C) in counter-
1. SWITCH OFF THE MAIN ELECTRICAL SUPPLY AT THE BREAKER ON THE WALL.
6. Repeat the procedure with the hot (ROUND, with UL marking on) wires. Always make sure that no wire
3. Affix back plate (A) to wall outlet box with back plate screws (D) provided.
INSTALLATION INSTRUCTIONS
ITEM REFERENCE NUMBER: SL2934